Fly fishing can be as challenging as it is fun. Learning how to cast with a fly rod takes lots of practice to master, but the basic technique is actually pretty easy to understand. Start by adjusting your line so it's rigged up properly to allow for a good cast. Then, try your hand at using the overhead cast. Once you master the basics, you can try using a roll cast to approach fish quietly and in harder to reach places!
[Edit]Steps
[Edit]Putting the Fly Fishing Rod Together
- Put together the segments of the fly fishing rod. Take the rod out of its case. Start with the 2 bottom pieces of the rod, which will be the largest ones. Slide the 2 pieces together and gently twist them to line up the 2 dots on the side. Then, slide the remaining pieces into the rod and line up the 2 dots of each section.[1]
- Don't force or twist the rod segments too hard or you could crack them.
- The segments will get thinner down the length of the rod.
- Slide the reel into the reel seat at the bottom of the rod. The small divot at the bottom of the rod is called the reel seat and is meant to hold the reel in place. Attach the reel to the rod by sliding the foot of the reel into the small opening at the top of the reel seat. Then twist the nut at the bottom of the reel seat to tighten it over the reel.[2]
- Wiggle the reel around to make sure it's securely attached.
- Make a loop knot at the end of the fly line. You'll use the end of the fly line to connect the leader (the thin line that connects the thick fly line to the tippet and fly lure) and tippet (an even thinner line that is nearly invisible to the fish and holds the fly lure) so you can string your lure. Give yourself plenty of slack in the fly line and form a loop knot at the end of it so you can easily attach the leader and change it out later if you want to.[3]
- Make sure the fly line is spooled tightly on the reel so it's less likely to form knots.
- Connect the leader to the end of the fly line with a fishing knot. The leader is a length of line that is used to transition from the thick fly line on the rod to the thin tippet that holds the lure. The leader starts thick at the end connected to the line and tapers down to a smaller line where it connects to the tippet. Tie a fishing knot to connect the leader to the fly line at the thicker end.[4]
- The leader also keeps the line from slapping the water and spooking the fish.
- The leader should be at least long to allow for adequate separation between the heavy fly line and the fly lure.
- Some leaders have metal clasps that you can use to attach to the loop in the fly line.
- Fix a tippet to the end of the leader by tying it securely with a knot. A tippet is a very thin line that attaches to the fly at one end and the leader at another. It's supposed to be nearly invisible in the water so the fish don't see the line connected to the fly. Connect a tippet to the end of the leader so it's secure and you can add a fly to the ned of the tippet.
- Attach a fly lure to the end of the tippet with a sturdy knot. The fly has a small hook on it that will snag the fish that takes the bait. Pass the tippet through the eye opening of the hook and use a fishing knot to connect the lightweight fly to the end of the tippet. Moisten the line to make it more pliable so you can tie a tighter knot.[6]
- Set the fly line about longer than the fishing rod. The weight of the fly line is what allows you to cast, so you need to have enough of the heavier line pulled out before you try to cast. An easy way to ensure you have enough fly line is to let out enough to reach the reel at the bottom of the rod with about of extra length.[7]
[Edit]Casting Overhead
- Use an overhead cast to get used to casting a fly fishing rod. The overhead cast is the standard fly fishing cast. Mastering the overhead cast requires knowing how to properly “load” the rod, which refers to finding the tension in the line and pole to cast the fly lure. Before you move on to more advanced casts, learn to use the overhead cast.[8]
- The overhead cast is harder to perform when there are lots of low hanging branches because the line can get tangled easily.
- Stand with your feet shoulder-width apart. For short to medium ranged casts, adopt a parallel stance so you're stable and in a better position to “feel” the weight of the fly line on the rod. Keep your feet evenly spaced apart and your weight centered rather than on the balls of your feet or your heels.[9]
- For longer casts, you may feel more comfortable standing with 1 foot forward so you can reach further behind you for a stronger cast without losing your balance.
- Hold the rod with your thumb on top of the grip. Don't squeeze too tightly or you won't be able to perform the quick stop at the end of the stroke. Keep a loose, comfortable grip and hold the rod in line with your intended target area.[10]
- Allow the rod to rest in your fingers and only squeeze the grip when you force it to stop at the end of each stroke.
- Keep the butt of the fly rod in line with your forearm.
- Make sure the reel of the rod is pointed down toward the ground.
- Lay the line straight on the ground in front of you. In order to generate enough momentum in your backswing, start by stretching out about of the line from the end of the rod. Aim the line completely straight and stand square to your target.[11]
- Make sure that the leader and tippet don't get tangled up.
- Bring the rod up and backward in 1 motion. Keep the tip of the rod low until you're ready to cast and use a smooth and fluid motion to bring the rod up and behind you. This will cause the rod to bend and load up with tension.[12]
- Think about snapping a long whip. The line should move up and overhead as it travels behind you in a large arc.
- Stop the rod abruptly once it passes a verticle position. When you straighten the rod out above your head and it passes behind you, stop its acceleration abruptly and deliberately so the line is launched behind you. Hold the rod still as the line travels backward.[13]
- Think about stopping the rod at about the 1 or 2 o'clock position behind you.
- Allow the line to unroll in the air behind you. With the rod still extended above and slightly behind you, wait for the line to travel behind you and rise as it unrolls. The energy from the backward motion will cause it to move until it extends completely.[14]
- Make sure you pause long enough to allow the line to fully unfurl.
- Move the rod forward to bring the line in front of you. As soon as the line is fully extended in the air behind you, use a smooth, accelerating stroke to bring the rod forward. The line will snap forward and form a loop in the air as it travels.[15]
- Keep your wrist straight and your elbow close to your body to generate a fluid movement.
- Lower the tip of the rod as the line unrolls in front of you. Stop the rod once it's about parallel with the ground to allow the energy in the line to propel it forward. As the line unrolls in front of you, slowly lower the tip of the rod to roll the line out all the way to the fly at the end. The line should end right where you were aiming.[16]
- Don't snap the rod down sharply or the tension in the line could cause the cast to go straight down before it has reached its target.
[Edit]Performing a Roll Cast
- Use the roll cast when you're fishing in narrow waterways. The roll cast will cause the line to smoothly unroll over the surface of the water and is less likely to disturb fish, but it's also a little more difficult to perform. It's also important that the line is in water because the water anchors it and allows you to create a loop.[17]
- A roll cast is great to use when you're fishing in narrow creeks or streams.
- The roll cast is also effective if you have a strong wind at your back that is interfering with your overhead cast.
- Draw the rod up and back to drag the end of the line across the water. Start with about of line laid out in front of you on the water and the tip of your rod pointed at the surface. Use a slow and smooth motion to bring the rod back and drag the line over the surface of the water.[18]
- Stop the stroke with the rod tip high when a loop has formed behind you. As soon as your rod reaches just past a vertical position, stop and hold it in position. The line should be slack and droop behind the tip of the rod, creating a loop.[19]
- The larger the loop, the more power you can generate to cast the line forward.
- Accelerate the rod forward quickly. Once you've formed the loop with the backward motion, quickly move the rod forward to start the forward cast. Keep your hand high and the rod pointed up. The line will start to roll over the surface of the water and move the direction of your cast.[20]
- Move forward with a smooth and consistent movement rather than a short and jerky motion.
- End the cast by stopping abruptly to allow the line to unroll. As you move your rod forward, the loop will rise up. Stop your cast abruptly once it's nearly parallel with the water. The loop will roll out on top of the water and move to where you're aiming your cast.[21]
- Allow the end of the line to land gently on the surface of the water.
[Edit]Things You'll Need
- Fly fishing rod
- Fly fishing reel
- Fly fishing line
- Tippet
- Leader
- Fly lure
[Edit]Video
[Edit]References
[Edit]Quick Summary
- ↑ https://youtu.be/CCONVJb8-SE?t=18
- ↑ https://youtu.be/CCONVJb8-SE?t=90
- ↑ https://blueridgemountainlife.com/fly-fishing-for-beginners-a-complete-guide/
- ↑ https://blueridgemountainlife.com/fly-fishing-for-beginners-a-complete-guide/
- ↑ https://news.orvis.com/fly-fishing/tuesday-tip-four-hot-tips-on-tippets
- ↑ https://www.flyfisherman.com/editorial/how-to-fly-cast-2/151833
- ↑ https://youtu.be/TAyj9KF_MQE?t=40
- ↑ https://www.flyfisherman.com/editorial/how-to-fly-cast-2/151833
- ↑ https://www.flyfisherman.com/editorial/how-to-fly-cast-2/151833
- ↑ https://www.flyfisherman.com/editorial/how-to-fly-cast-2/151833
- ↑ https://www.fix.com/blog/basic-fly-casting-techniques/
- ↑ https://blueridgemountainlife.com/fly-fishing-for-beginners-a-complete-guide/
- ↑ https://blueridgemountainlife.com/fly-fishing-for-beginners-a-complete-guide/
- ↑ https://blueridgemountainlife.com/fly-fishing-for-beginners-a-complete-guide/
- ↑ https://www.fix.com/blog/basic-fly-casting-techniques/
- ↑ https://www.fix.com/blog/basic-fly-casting-techniques/
- ↑ http://www.flyfishingforbeginners.com/techniques/casting/roll-cast/
- ↑ https://youtu.be/b3K15_T8aO8?t=27
- ↑ https://youtu.be/b3K15_T8aO8?t=27
- ↑ https://www.fix.com/blog/basic-fly-casting-techniques/
- ↑ https://youtu.be/b3K15_T8aO8?t=93
from How to of the Day https://ift.tt/2Ausyxv
via Peter
No comments:
Post a Comment